Hi guys, I'm trying to find the adress to access the Hiltron modem configuration once it's put in bridge mode. I remember seeing the information "somewhere" in the community hub the the search tools are not finding the right discussion. could anyone chime in?
Hi George
You can reset the modem to original factory settings by pressing and holding for 10+ seconds the small button at the back of your modem, with a pen or a paperclip.
Hi PsykoB
There are several customers to use their own router with the Fizz modem in bridge mode.
There has been no recent discussion or mention about bufferbloat issues...
Hi PsykoB
As per above posts, once you put the Fizz modem in bridge mode and setup your mesh network, WI-FI will work well with your google pucks.
Also this is a good...
I recently tried out a new router and then put my modem in bridge mode, but I have removed the router and I did not put the modem out of bridge mode yet - I cannot access...
you can try to reset to original settings by pressing and holding for 20 seconds the small button at the back of your modem, with a pen or a paperclip.
Hello people!
I just subscribed to Fizz Internet and got installed on friday. I did set my modem in bridge mode as I have another full featured router/set of APs...
Hi Joe,
Please make sure to restart both modem and router after changes.
The only other suggestions I can offer are:
- Do a factory reset of the Fizz modem. Using a...
